TECHNICAL ADVICE DISCLAIMER

This forum contains extensive guides, advice and solutions to repairing Landcrabs. Bear in mind that most here are amateur repairers and restorers and that information and advice is freely given with good intent. However, be aware that it is your choice whether or not to act upon that information. If you have any doubts as to your own abilities to carry out a repair to a suitable safe standard or question the accuracy of any advice offered, we suggest you seek professional assistance. The Landcrab Forum and its members will not be held liable for the consequences of any incorrect repairs based on advice offered here. Members are asked to ensure that to the best of their knowledge all advice that they post is accurate and provide references where available. In the event of any uncertainty this should be made clear in the post.

Lock washers

new

« Prev
1
Next »

dave1800
Global Moderator

Posts: 3,589
Attribute: Technical Guru.

Lock washers Jan 20, 2018 14:54:54 GMT

Quote

Post by dave1800 on Jan 20, 2018 14:54:54 GMT

Does anyone here have any experience of using these lock washers. I am thinking of the tie rod nuts that have a habit of coming loose with potentially disastrous results. Many solutions were tried by BMC especially in Australia with varying degrees of success. On the face of it these look promising?

Lock washers

David

Penguin45 Administrator Admin Posts: 4,560 Attribute: Compulsive rust poker.	Lock washers Jan 20, 2018 21:27:45 GMT Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by Penguin45 on Jan 20, 2018 21:27:45 GMT That's very clever. Cylinder head nuts might benefit as well. Very expensive though. Chris.
	What would you like welding up?

TECHNICAL ADVICE DISCLAIMER

Lock washers

Post by dave1800 on Jan 20, 2018 14:54:54 GMT

Post by Penguin45 on Jan 20, 2018 21:27:45 GMT